Non-Glass Sample Cells

A precision, non-glass sample cell for the study of Boron, Fluorine, Silicon and other types of samples that may be deemed “hazardous”. Available in 5mm and 10mm versions, these precision machined cells fit smoothly into the respective standard thin wall sample tubes. A cap, made of the same material, screws into the top of the cell, providing a positive closure and the means for removing the cell with a threaded rod.

Boron and Silicon samples can be studied by supporting the cell in a glass sleeve so that only the cell is in the receiver coil area. With the cap secured to the top of the cell, a threaded rod is screwed into the top of the cap. This unit is slipped through a glass sleeve and is held in place by the support rod with a modified tube cap. Depending on the positioning of the poly cell in the RF coil area, it may be desirable to cut off excess length of the support rod.

Tests with Chloroform-d / TMS samples have shown line widths comparable to using the sample tube alone. Some additional shimming may be necessary. Individual results may vary and are dependent upon how well the instrument is tuned. We can offer no guarantee on performance and safety, especially with “hazardous” samples.

Specifications 
Sample Cell, 5mm version 3.3mm ID x 4.1mm OD x 90mm long, 80mm maximum sample height
Sample Cell, 10mm version: 7.5mm ID x 8.9mm OD x 90mm long, 80mm maximum sample height
Cap, 5mm version: 20mm long with 4-40 internal thread
Cap, 10mm version: 20mm long with ¼-20 internal thread
View as Grid List
Sort by
Display per page

NE-205-5

Glass Sleeve for use with 5mm Non-Glass Sample Cells
Precision 5mm OD x 120mm long

$16.29

NE-205-10

Glass Sleeve for use with 10mm Non-Glass Sample Cells

Precision 10mm OD x 120mm long

$26.71

NE-341-10

Support Rod, for use with Non-Glass Sample Cells, Glass Sleeve and Support
PVC; 1/4” x 8”, ¼ -20 thread

From $23.20